Rep 6.7 Lamp Wire Harness - Xerox workcentre 5335 series Service Manual

Figure 4 LED Lamp PWB Tightening Sequence
Initial Issue
WorkCentre 5335 Family Service Documentation

REP 6.7 Lamp Wire Harness

Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the following parts:
• Platen Cover or DADF Assembly
• IIT Rear Cover
3. Disconnect the Lamp Wire Harness
(1) Move the Block of the Connector Housing in the direction of the arrow.
(2) Disconnect the Lamp Wire Harness.
4. Remove the Full Rate Carriage
(1) Move the Full Rate Carriage to the notch on the frame.
(2) Remove the screws (x2).
(3) Remove the Full Rate Carriage.
07/2011
4-45
BUS Updated 12/2011
PL 1.2
(REP 5.1)
(PL 1.1)
(Figure 1)
Figure 1 Lamp Wire Harness
(Figure 2)
Repairs & Adjustments
REP 6.6, REP 6.7