Rep 13.8 Rear Lower Cover (Office Finisher Lx) - Xerox workcentre 5335 series Service Manual

REP 13.8 Rear Lower Cover (Office Finisher LX)

Parts List on PL 23.6
Removal
1. Switch off the power and disconnect the power cord.
2. Undock the Finisher (REP 13.5).
3. Remove the Rear Lower Cover.
(1) Remove the screws (3).
(2) Remove the Cover.
Replacement
1. To install, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5335 Family Service Documentation
REP 13.9 Eject Cover (Office Finisher LX)
Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Eject Cover
(1) Unlatch the Eject Cover, and move it to the left.
(2) Remove the Retaining Screw (1).
(3) Push the Latch through the hole in the Cover.
(4) Remove the Cover by moving it to the left.
Retaining
Screw
Eject
Cover
Latch
07/2011
4-143
BUS Updated 12/2011
PL 23.10
(Figure 1).
Figure 1 Removing the Eject Cover
Repairs & Adjustments
REP 13.8, REP 13.9