Table of Contents
Advertisement
REP 3.1 HDD
Parts List on
PL 35.3
Removal
ESD procedures must be used when removing or replacing PWBs. Damage to electrical com-
ponents is likely if static discharge reaches components.
Always wear a wrist strap to protect electrical parts from static damage. If a wrist strap is not
available, touch some metallic parts to discharge the static electricity before servicing.
1.
Switch off the power and disconnect the power cord.
2.
Remove the following covers
(Figure
a.
Pull off the ESS Cap Cover.
b.
ESS Cover (2 Screws).
c.
Left Rear Middle Cover (2 Screws).
d.
Rear Lower Cover (3 Screws).
a
b
Figure 1 Removing Covers
Initial Issue
WorkCentre 5335 Family Service Documentation
CAUTION
1).
c
d
BUS Updated 12/2011
3.
Remove the HDD
(Figure
2).
a.
Disconnect the connectors (2).
b.
Release the Locking Tab and remove the HDD.
b
Figure 2 Removing HDD
Replacement
1.
To reinstall, carry out the removal steps in reverse order.
07/2011
4-3
a
Repairs & Adjustments
REP 3.1
Advertisement
Table of Contents
