Of 99-6 2 Wire Motor Open; Of 99-7 2 Wire Motor On - Xerox workcentre 5335 series Service Manual

OF 99-6 2 Wire Motor Open

Procedure
NOTE: Before performing this RAP, ensure that the motor is free to rotate.
NOTE: To view the Circuit Diagram for this procedure refer to
Enter the Component Control [XXX-XXX].
There is +24VDC measured between Pin 3(+) of the PWB and GND(-).
Y N
There is +24VDC measured between the Motor Pin 2(+) of the Motor and GND(-).
Y N
There is +24VDC measured between the Motor Pin 1(+) of the Motor and GND(-).
Y N
There is +24VDC measured between the PWB Pin 4(+) of the PWB and GND(-
).
Y N
Replace the PWB.
Check the wire between the PWB Pin 4 and the Motor Pin 1 for an open circuit
or poor contact.
Replace the motor.
Check the wire between the PWB Pin 3 and the Motor Pin 2 for an open circuit or poor
contact.
Replace the PWB.
Figure 1 Motor CD
Initial Issue
WorkCentre 5335 Family Service Documentation

OF 99-7 2 Wire Motor On

Procedure
NOTE: To view the Circuit Diagram for this procedure refer to
(Figure 1). Turn off the power. Remove the PWB connector. There is 10 Ohm's or less measured
between the connector Pin 3 and the frame.
Y
Check the wire between the connector Pin 3 and the motor Pin 2 for a short circuit.
If the check is OK, replace the motor.
07/2011
2-1033
BUS Updated 12/2011
N
Replace the PWB.
Figure 1 Motor CD
(Figure 1).
Status Indicator RAPs
OF 99-6, OF 99-7