Aligning/Orientation Of The Gears And Stack Height Sensor Flag - Xerox workcentre 5335 series Service Manual

2
Position the 2 Gears
Figure 14 Aligning the Gears and Stack Height Sensor Flag
8. Attach the Spring to the gear and slide the Gear into position.
9. Ensure that the 2 Gears and Stack Height Sensor Flag is in the position shown
15) and install the E-ring.
Initial Issue
WorkCentre 5335 Family Service Documentation
1
Rotate shaft until Stack
Height Flag is in position
(Figure
10. Install the Bushing onto the front end of the Set Clamp Shaft and install the E-ring
07/2011
4-157
BUS Updated 12/2011
Pinion Gear
Shaft Gear
Install the E-
position
position on Pin-
ring
ion Gear
Figure 15 Orientation of 2 Gears and Stack Height Sensor Flag
16).
Flag
(Figure
Repairs & Adjustments
REP 13.17