Disconnecting The Set Clamp Holder Springs; Removing The Front E-Ring From The Set Clamp Shaft - Xerox workcentre 5335 series Service Manual

Disconnect spring from the
Holders (3)
Figure 4 Disconnecting the Set Clamp Holder Springs
14. Remove the front E-ring and the bushing from the Set Clamp Shaft Assembly
Repairs & Adjustments
REP 13.17
NOTE: Notice the position and orientation of the Set Clamp Shaft gear and the cam gear
that it engages. When installing the Set Clamp Shaft these gears must engage in the
same manner
15. Remove the rear E-ring from the Set Clamp Shaft
(Figure 5).
07/2011
4-152
BUS Updated 12/2011
Figure 5 Removing the front E-ring from the Set Clamp Shaft
(Figure 6).
(Figure
WorkCentre 5335 Family Service Documentation
Remove
the E-
ring and
the
bushing
7).
Initial Issue