Rep 19.4 Hcf Tray Cables; Gear Bracket Assembly; Lift Shaft Rear Tray Cable Pulley; Preparing To Remove The Rear Tray Cable - Xerox workcentre 5335 series Service Manual

REP 19.4 HCF Tray Cables

Parts List on PL 10.3
Removal
Switch off the power and disconnect the power cord.
Removing the HCF Rear Tray Cables
1. Remove the HCF Tray (REP 19.1)
2. Remove the Gear Bracket Assembly
3
Remove the screws (3)
2
Remove the gears
(2)
1
Remove the oval
shaped Plate
4
Remove the Gear
Bracket Assembly
Figure 1 Gear Bracket Assembly
3. At the rear of the HCF Tray, begin to free up movement of the Tray Cable Pulley
2).
Initial Issue
WorkCentre 5335 Family Service Documentation
(Figure 1).
BUS Updated 12/2011
2
Slide the Bushing away
from the frame
1
Remove the E-ring
Figure 2 Lift Shaft Rear Tray Cable Pulley
NOTE: You will not be able to release the cable ends from underneath the Tray Cable Pulley
until you perform the next step, which puts slack in the cable enabling the Lift Shaft to be disen-
gaged from its bracket, and the Tray Cable Pulley moved farther to the left releasing the cable
ends.
4. Prepare to remove the Rear Tray Cable
(Figure
Figure 3 Preparing to remove the Rear Tray Cable
07/2011
4-179
Tray Cable Pulley
(Figure 3).
Remove the E-Rings
(2), Wire Guides (2),
and Pulleys (2)
Repairs & Adjustments
REP 19.4