Rep 5.1 Dadf - Xerox workcentre 5335 series Service Manual

REP 5.1 DADF

Parts List on PL 51.1
Removal
1. Switch off the power and disconnect the power cord.
2. Loosen the screws (x2) and disconnect the connector.
(1) Disconnect the connector.
Figure 1 Connector
3. Remove the DADF. (Figure 2)
(1) Tilt the Counter Balance in the direction of the arrow and remove it from the
installation holes.
Figure 2 Tilt Counter Balance
Replacement
1. To install, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5335 Family Service Documentation
2.
(Figure 1)
3.
07/2011
4-13
BUS Updated 12/2011
Install the DADF. (Figure 3)
(1) Insert the tabs of the Counter Balance into the grooves of the installation holes.
Figure 3 Inserting Tabs
Perform ADJ 5.3 DADF Original Detection Correction.
Repairs & Adjustments
REP 5.1