Rep 19.9 Hcf Casters; Rep 19.10 Hcf Takeaway Roll - Xerox workcentre 5335 series Service Manual

REP 19.9 HCF Casters

Parts List on PL 10.8
Removal
1. Switch off the power and disconnect the power cord.
2. Un-dock the HCF (REP 19.3).
3. Remove all paper from the HCF Tray.
4. Roll the HCF away from the copier/printer.
5. Turn the HCF over onto its left side to expose the casters on the underside of the HCF.
6. Remove (3) installation screws per caster.
Replacement
1. Install a new caster or casters, by tightening the (3) installation screws per caster.
2. Turn the HCF back up to an upright position.
3. Roll the HCF back toward the copier/printer.
4. Place previously removed paper, or fresh paper, into the HCF Tray.
5. Dock the HCF.
Repairs & Adjustments
REP 19.9, REP 19.10

REP 19.10 HCF Takeaway Roll

Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the HCF Feed Motor
3. Remove the Lower Chute
• Remove the (2) securing screws.
4. Slide the Takeaway Roll to the right until the left side is released, then lower the roll to
remove.
Replacement
1. To install, carry out the removal steps in reverse order.
2. After replacing, reset
07/2011
4-186
BUS Updated 12/2011
PL 10.7
(REP 19.12).
(Figure 1).
Takeaway Roll (includes Shaft)
Figure 1 Removing the Lower Chute
HFSI Counter 954-805.
WorkCentre 5335 Family Service Documentation
Initial Issue