116-338 Jba Rap; 116-339 Jba No Hd Rap - Xerox workcentre 5335 series Service Manual

116-338 JBA RAP

A JBA (Job Based Accounting) processing error caused an internal shutdown.
Initial Actions
Power Off/On
Procedure
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
• Replace RAM DIMM on ESS PWB (PL
• Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB)
Status Indicator RAPs
116-338, 116-339
35.2)
BUS Updated 12/2011

116-339 JBA No HD RAP

When the JBA is started up, the HDD is not installed.
Procedure
• Check the HDD electrical connections
• Check the sw version of the controller sw - update if required
• If the problem persists perform
• Perform GP 14 - only the first two parts - make sure to follow sequence and heed cau-
tions
1. Job Log Clear Mode
2. HDD Initialize Mode
• Replace HDD (PL 35.2)
• Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB)
07/2011
2-860
(PL 35.2).
Hard Disk Failure Prediction Test.
WorkCentre 5335 Family Service Documentation
Initial Issue