Rep 10.3 Fuser; Rep 10.4 Fuser Exit Sensor - Xerox workcentre 5335 series Service Manual

REP 10.3 Fuser

Parts List on PL 7.1
Removal
The Fuser is Hot, do not start servicing the Fuser until has cooled down.
1. Switch off the power and disconnect the power cord.
2. Open the Left Hand Cover and remove the Fuser
a. Loosen the knobs (2).
b. Hold the Fuser by the handles and remove it.
Figure 1 Removal
Replacement
1. To install, carry out the removal steps in reverse order.
Repairs & Adjustments
REP 10.3, REP 10.4
CAUTION
(Figure 1).
b
a
BUS Updated 12/2011

REP 10.4 Fuser Exit Sensor

Parts List on PL 7.1
Removal
The Fuser is Hot, do not start servicing the Fuser until has cooled down.
1. Switch off the power and disconnect the power cord.
2. Open the Left Hand Cover and remove the Fuser
a. Loosen the knobs (2).
b. Hold the Fuser by the handles and remove it.
3. Remove the Plate (1 Screw) (Figure
3
Figure 2 Removing Screw
07/2011
4-84
CAUTION
(Figure 1).
b
a
Figure 1 Removal
2).
WorkCentre 5335 Family Service Documentation
Initial Issue