Table of Contents
Advertisement
024-984 Booklet Low Staple Front RAP
BSD-ON:
BSD 12.21 - Office Finisher LX Staple Control
The Booklet Low Staple Software detects low staple condition just before Booklet Staple Front
starts operating.
Procedure
•
Go to
012-291
(Office Finisher LX).
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
Initial Issue
WorkCentre 5335 Family Service Documentation
024-989 Booklet Low Staple R RAP
BSD-ON:
1.
Booklet Stapler Low Staple R signal ON was detected just before Stapling operation.
2.
Booklet Stapler Low Staple R signal was detected at Power ON, at initialization, or when
the interlock was closed.
Procedure
•
Check for Staple needles and reload them correctly.
If the problem persists, refer to the
of 2 - Rear)
(GP
16)
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
07/2011
2-427
BUS Updated 12/2011
BSD 12.27 - Office Finisher Booklet Staple Control (2 of 2 - Rear)
BSD 12.27 - Office Finisher Booklet Staple Control (2
and check the Rear Low Staple Switch circuit for an open or short.
(GP
16)
Status Indicator RAPs
024-984, 024-989
Advertisement
Table of Contents
