Rep 7.3 Tray 3 Cable - Xerox workcentre 5335 series Service Manual

Support the MSI when removing the screws to prevent damaging the MSI.
4. Remove the screws (2) and slide out the MSI
Figure 3 Removing Screws
Replacement
1. To reinstall, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5335 Family Service Documentation
CAUTION
(Figure 3).
4
BUS Updated 12/2011

REP 7.3 Tray 3 Cable

Parts List on PL 11.3
Removal
NOTE: This procedure shows the removal of the Front Cables, the steps to remove and
replace the Rear Cables are the same.
NOTE: The Screws used in the Tray are of different Length and Threads, keep the screws with
the parts for correct replacement.
1. Switch off the power and disconnect the power cord.
2. Remove Paper Tray 3 REP 7.1.
3. Remove the Tray 3 Cover (Figure
a. Remove the Screws (2).
b. Remove the Cover.
Figure 1 Cover Removal
07/2011
4-55
1):
Repairs & Adjustments
REP 7.2, REP 7.3