Rep 5.6 Dadf Pwb - Xerox workcentre 5335 series Service Manual

REP 5.6 DADF PWB

Parts List on PL 51.2
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the DADF Rear Cover. (REP
3. Disconnect the DADF PWB connectors.
(1) Disconnect the connectors (x6).
Figure 1 DADF PWB Connectors
4. Remove the DADF PWB. (Figure 2)
(1) Remove the self-tapping screws (x2) and the Ground Wires (x2).
(2) Remove the self-tapping screws (x2).
(3) Remove the DADF PWB.
Figure 2 DADF PWB Removal
Repairs & Adjustments
REP 5.6
5.4)
(Figure 1)
BUS Updated 12/2011
Replacement
1. To install, carry out the removal steps in reverse order.
2. Switch the ROM on the new PWB with the EEPROM from the old PWB.
This is because it stores the alignment value of the DADF.
3. Check the software version. Update the version if an old software is installed in the new
PWB.
07/2011
4-18
(Figure
Figure 3 ROM
WorkCentre 5335 Family Service Documentation
3)
Initial Issue