Omron R88D-GT series User Manual page 385

 Displays on the Parameter Unit
• Connect the Parameter Unit to the Servo Drive and turn ON the power to the Servo Drive, or
alternatively, connect the Parameter Unit to the Servo Drive when power to the Servo Drive is
already ON. The following displays will appear.
8.8.8.8.8.8.
8.8.
· The Parameter Unit is initialized.
The display will flash every 0.6 s.
Servo Drive with unit number other than 0
Communicating via RS-232 Only
Ukekrk1.0k0k
k1
1 s
rk k k k k0k
k1
0.6 s 0.6 s
. . . . . .
. .
The microcomputer
version is displayed.
(The numbers depend on
the microcomputer
version.)
The Drive's unit number
set in parameter Pn00 is
displayed.
Default Display
(Determined
by the setting of
parameter Pn01.)
6-2 Preparing for Operation
0.6 s
8k8k8k8k8k8k
8k8kk
Servo Drive with unit number 0
Communicating with Other Drives
connected via RS-485
Ukekrk1.0k0k
The Parameter Unit
version is displayed.
k0.
The dot will flash if RS-485 is
connected. Set the unit number
of the Drive to connect to using
the Increment and Decrement
keys.
Ukekrk1.0k0k
The Parameter Unit
version is displayed.
k3.
The specified unit number
is displayed.
Press the Data key.
(0.6 s later)
rk k k k k0k
Default Display
k3.
The specified unit number
is displayed.
6
6-4