Front Wheel Assembly Removal And Installation - Suzuki GSX1300R Manual

Front Wheel Assembly Removal and Installation

Removal
1) Remove the rear under cowling and side cowlings.
Refer to "Exterior Parts Removal and Installation in
Section 9D (Page 9D-14)".
2) Raise the front wheel off the ground and support the
motorcycle with a jack or a wooden block.
CAUTION
!
Do not carry out the work with the
motorcycle resting on the side-stand. Do not
support the motorcycle with the exhaust
pipes. Make sure that the motorcycle is
supported securely.
3) Remove the reflex reflector for E-03, 24, 28, 33.
4) Disconnect the brake hose clamp (1) from the front
fender.
5) Disconnect the brake hose (2) from the brake hose
clamp (3).
6) Remove the front fender by removing the bolts (4),
left and right.
4
1
2
B815H22406003
1
I815H1240004-01
3
4
I815H1240005-01
7) Remove the brake calipers, left and right.
CAUTION
!
Do not operate the brake lever with the
caliper removed.
8) Loosen two axle pinch bolts (5) on the right front fork
leg.
9) Remove the front axle bolt (6).
6
10) Loosen two axle pinch bolts (7) on the left front fork
leg.
11) Draw out the front axle and remove the front wheel.
12) Remove the collar (8) (RH only).
NOTE
After removing the front wheel, fit the
calipers temporarily to the original positions.
7
Wheels and Tires: 2D-4
I823H1240003-01
5
I815H1240006-01
8
I815H1240007-02