Ect Sensor Removal And Installation; Fuel Meter Inspection - Suzuki GSX1300R Manual

ECT Sensor Removal and Installation

Refer to "ECT Sensor Removal and Installation in
Section 1C (Page 1C-5)".

Fuel Meter Inspection

Inspect the fuel meter in the following procedures:
1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
2) Disconnect the fuel pump lead wire coupler (1).
3) Connect a variable resistor (2) between the B/Lg and
B/W lead wires of the wire harness side coupler.
B815H29306006
B815H29306007
1
I815H1930024-01
B/Lg
2
B/W
I823H1930010-03
Combination Meter / Fuel Meter / Horn:
4) Turn the ignition switch ON.
5) Check the fuel meter (3) and indicator light (LED) (4)
operations when the resistance is adjusted to the
specified values.
If either one or both indications are abnormal,
replace the combination meter with a new one. Refer
to "Combination Meter Removal and Installation
(Page 9C-2)".
4
3
NOTE
It takes approx. 30 seconds that the fuel
meter indicates the detected fuel level.
Fuel meter
Needle position
6) Connect the fuel level gauge coupler and reinstall
the fuel tank.
Refer to "Fuel Tank Removal and Installation in
Section 1G (Page 1G-9)".
A
B
C
I815H1930011-02
Resistance
LED
Approx. 118 Ω
ON
Approx. 96 Ω
ON
Approx. 63 Ω
OFF
Approx. 23 Ω
OFF
I815H1930012-04
9C-5