Suzuki GSX1300R Manual page 272

1D-51 Engine Mechanical:
• Install the valve spring seat.
• Apply engine oil to the oil seal (6), and press-fit it into
the position.
CAUTION
!
Do not reuse the removed oil seal.
• Insert the valve, with its stem coated with
molybdenum oil solution all around and along the full
stem length without any break.
CAUTION
!
When inserting the valve, take care not to
damage the lip of the oil seal.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• Install the valve spring with the small-pitch portion "G"
facing cylinder head.
"I"
"H"
"G"
"G": Small-pitch portion
H": Large-pitch portion
6
I823H1140124-04
I705H1140165-01
"J"
I823H1140304-02
"I": Upward
"J": Paint
• Put on the valve spring retainer (7), and using the
special tools, press down the spring, fit the cotter
halves to the stem end, and release the lifter to allow
the cotter halves to wedge in between retainer and
stem.
CAUTION
!
• Be sure to restore each spring and valve to
their original positions.
• Be careful not to damage the valve and
valve stem when handling them.
• Be careful not to damage the tappet sliding
surface with the special tool.
Special tool
(A): 09916–14510 (Valve spring compressor)
(B): 09916–14522 (Valve spring compressor
attachment)
(C): 09919–28620 (Sleeve protector)
: 09916–84511 (Tweezers)
(A)
(B)
I823H1140125-01
(C)
7
I823H1140126-04