Oil Pressure Switch Inspection; Ignition Switch Inspection; Ignition Switch Removal And Installation - Suzuki GSX1300R Manual

9C-8 Combination Meter / Fuel Meter / Horn:

Oil Pressure Switch Inspection

Inspect the oil pressure switch in the following
procedures:
NOTE
Before inspecting the oil pressure switch,
check if the engine oil level is correct. Refer
to "Engine Oil and Filter Replacement in
Section 0B (Page 0B-10)".
1) Remove the right side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
2) Disconnect the oil pressure switch lead wire from the
oil pressure switch.
3) Inspect the oil pressure switch for continuity with the
tester. If any abnormality is found, replace the oil
pressure switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
Position
ON
(Engine is at stop.)
OFF
(Engine is running.)
4) After finishing the oil pressure switch inspection,
reinstall the removed parts.

Ignition Switch Inspection

Inspect the ignition switch in the following procedures:
1) Remove the upper cover and body cowling cover.
Refer to "Exterior Parts Removal and Installation in
Section 9D (Page 9D-14)".
2) Disconnect the ignition switch lead wire coupler (1).
1
B815H29306014
G/Y Ground
I823H1930033-01
B815H29306015
I815H1180013-01
3) Inspect the ignition switch for continuity with a tester.
If any abnormality is found, replace the ignition
switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
E-02, 19, 24
Color
R
Position
ON
OFF
LOCK
P
E-03, 28, 33
Color
R O
Position
ON
OFF
LOCK
P
4) After finishing the ignition switch inspection, reinstall
the removed parts.

Ignition Switch Removal and Installation

Refer to "Ignition Switch Removal and Installation in
Section 1H (Page 1H-12)".
O Gr Br
I823H1930019-02
O/Y Bl Gr Br
I815H1930023-01
B815H29306016