Suzuki GSX1300R Manual page 575

• Tighten the clutch sleeve hub nut to the specified
torque.
Tightening torque
Clutch sleeve hub nut: 150 N·m (15.0 kgf-m, 108.5
lb-ft)
• Lock the clutch sleeve hub nut with a center punch.
• Install the spring washer seat (9) and spring washer
(10) onto the clutch sleeve hub correctly.
9
• Insert the clutch drive plates and driven plate one by
one into the clutch sleeve hub in the prescribed order.
NOTE
Insert the outermost No. 2 drive plate claws
"E" to the other slits "F" of clutch housing as
shown in the figure.
F
"E"
I815H1530046-01
10
I823H1530047-01
I815H1530056-01
12
11
14
15
11. No. 3 drive plate
12. No. 1 drive plate
13. No. 2 drive plate
14. No. 2 driven plate (1 – 4 pcs.)
: The No. 1 and No. 2 driven plates are 9 in total.
15. No. 1 driven plate (8 – 5 pcs.)
: The No. 1 and No. 2 driven plates are 9 in total.
"G": Direction of outside
NOTE
Three kinds of the drive plate (No. 1, No. 2
and No. 3) are equipped in the clutch system,
they can be distinguished by the inside
diameter and clutch facing "H".
"H": Clutch facing
: Make sure to check the numbers of clutch facing, before installing
them.
Drive plate I.D.
No. 1 126 mm (4.96 in)
No. 2 127 mm (5.00 in)
No. 3 135 mm (5.31 in)
NOTE
Two kinds of the driven plate (No. 1 and No.
2) are equipped in the clutch system, they
can be distinguished by the thickness.
The No. 1 and No. 2 driven plates are 9 pcs. in
total. 5 – 8 pcs. of No. 1 driven plates are
used with 4 – 1 pc(-s). of No. 2 driven plate(-s)
as a set.
The No. 2 driven plate(-s) must be installed to
4th to 7th position of driven plates order from
the sleeve hub side.
Driven plate
No. 1
No. 2
Clutch: 5C-19
13
"G"
14/15 15
I823H1530049-03
"H"
I823H1530050-02
Clutch facing "H"
36 pcs.
60 pcs.
60 pcs.
Thickness
2.0 mm (0.08 in)
2.3 mm (0.09 in)