Suzuki GSX1300R Manual page 271

• Set the clamp screws as shown in the figure.
"D"
"B": Upper
• Install the thermostat.
NOTE
The air bleeder hole "F" of the thermostat
faces upside.
• Tighten the thermostat cover bolts (4) to the specified
torque.
Tightening torque
Thermostat cover bolt (d): 10 N·m (1.0 kgf-m, 7.0
lb-ft)
"F"
"B"
" a" "a "
"C"
"C": Lower "D": Left
4
(d)
I823H1140122-04
" a "
"a "
"E": Right
• Tighten the ECT sensor (5) to the specified torque.
Tightening torque
Engine coolant temperature sensor (e): 18 N·m (
1.8 kgf-m, 13.0 lb-ft)
CAUTION
!
• Take special care when handling the
temperature sensor. It may cause damage
if it gets a sharp impact.
• Replace a gasket with a new one.
Engine Mechanical: 1D-50
"E"
I823H1140121-03
"a": 45°
5
(e)
I823H1140123-03