Suzuki GSX1300R Manual page 41

3) Tighten the oil drain plug (1) to the specified torque.
CAUTION
!
Replace the gasket washer with a new one.
Tightening torque
Oil drain plug (a): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
1
4) Pour new oil through the oil filler. When performing
an oil change (without oil filter replacement), the
engine will hold about 3.1 L (3.3/2.7 US/lmp qt) of oil.
Use of SF/SG or SH/SJ in API with MA in JASO.
5) Start up the engine and allow it to run for several
minutes at idling speed.
6) Turn off the engine and wait about three minutes.
7) Hold the motorcycle vertically and check the oil level
through the inspection window (3). If the oil level is
below the "L" line, add oil to the "F" line. If the level is
above the "F" line, drain the oil until the level reaches
the "F" line.
F
L
Oil Level Inspection
1) Place the motorcycle on the side-stand.
2) Start up the engine and allow it to run for several
minutes at idle speed.
(a)
I815H1020022-01
3
I815H1020023-01
Maintenance and Lubrication:
3) Turn off the engine and wait about three minutes.
4) Hold the motorcycle vertically and check the oil level
through the inspection window (1). If the level is
below "L" line, add oil to "F" line. If the level is above
"L" line, drain oil to "F" line.
F
L
Oil Filter Replacement
1) Drain engine oil as described in the engine oil
replacement procedure.
2) Remove the right side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
3) Remove the oil filter (2) using the special tool.
Special tool
(A): 09915–40610 (Oil filter wrench)
4) Apply engine oil lightly to the O-ring of new oil filter,
before installation.
CAUTION
!
ONLY USE A GENUINE SUZUKI
MOTORCYCLE OIL FILTER.
Other manufacturer's oil filters may differ in
thread specifications (thread diameter and
pitch), filtering performance and durability
which may lead to engine damage or oil
leaks. Also, do not use a genuine Suzuki
automobile oil filter on this motorcycle.
0B-11
1
I815H1020024-01
(A)
2
I815H1020025-01