Starter Torque Limiter / Starter Clutch Removal And Installation - Suzuki GSX1300R Manual

7) Measure the voltage between R and B lead wires
using the multi-circuit tester when shifting the
gearshift lever from low to top.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe
set)
Tester knob indication
Voltage ( )
Gear position switch voltage (Except neutral
position)
0.6 V and more ((+) R – (–) B)
(B)
8) Turn the ignition switch OFF.
9) Install the removed parts.
Starter Torque Limiter / Starter Clutch Removal
and Installation
Removal
1) Drain engine oil.
2) Remove the right side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
3) Remove the starter torque limiter cover (1).
1
(A)
V
I823H1110073-02
B815H21906009
I815H1190009-01
4) Remove the gasket (2) and dowel pins.
5) Remove the starter torque limiter (3) and its shaft (4).
3
6) Remove the starter clutch cover (5).
7) Remove the gasket (6) and dowel pins.
8) Remove the wave washer (7), starter idle gear (8)
and its shaft (9).
7
5
Starting System: 1I-10
2
4
I815H1190010-01
5
I815H1190011-02
9
6
I815H1190012-01