Tp Reset; Engine Assembly Removal - Suzuki GSX1300R Manual

1D-19 Engine Mechanical:
NOTE
The learned value of the ISC valve is set at
RESET position.
6) Close the SDS tool.
7) Turn the ignition switch OFF position.
NOTE
The ISC valve opening initialization is
automatically started after the ignition switch
is turned OFF.

TP Reset

When replacing the throttle body assembly or TP sensor
with a new one or reinstalling the TP sensor, reset the
TP learned value in the following procedures:
1) Turn the ignition switch OFF position.
2) Connect the special tool to the dealer mode coupler
and turn its switch ON position. Refer to "Self-
Diagnostic Procedures in Section 1A (Page 1A-12)".
3) Turn the ignition switch ON position (and wait more
than 2 seconds) to clear the TP learned value.
CAUTION
!
Do not open the throttle when clearing the TP
learned value.
4) Turn the ignition switch OFF position.
5) Turn the special tool OFF position and remove it
from the dealer mode coupler.

Engine Assembly Removal

Before taking the engine out of the frame, wash the
engine using a steam cleaner. Engine removal is
sequentially explained in the following steps:
1) Remove th side cowlings. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
2) Disconnect the battery (–) lead wire.
I823H1140531-03
3) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
4) Drain engine coolant. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
5) Lift and support the fuel tank. Refer to "Fuel Tank
B815H21406016 Removal and Installation in Section 1G (Page 1G-
9)".
6) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation (Page 1D-6)".
7) Remove the throttle body assembly. Refer to
"Throttle Body Removal and Installation (Page 1D-
10)".
8) Remove the horn (1) with its bracket.
B815H21406017
I815H1140065-01
1
I815H1140066-01