Suzuki GSX1300R Manual page 262

1D-41 Engine Mechanical:
CAUTION
!
Make sure that the adjuster works properly
by checking no slack at point "B".
• Tighten the valve timing inspection cap (5) and starter
clutch cover cap (6) to the specified torque.
Tightening torque
Valve timing inspection cap (b): 23 N·m (2.3 kgf-
m, 16.5 lb-ft)
Starter clutch cover cap (c): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
Cylinder Head Cover
• Check and adjust the valve clearance. Refer to "Valve
Clearance Inspection and Adjustment in Section 0B
(Page 0B-4)".
• Pour engine oil in each oil pocket in the cylinder head.
"B"
I823H1140575-03
5
(b)
6
(c)
I815H1140054-01
I823H1140088-01
• Install the dowel pins and new gaskets to the cylinder
head cover.
• Apply bond to the cam end caps of the gasket as
shown in the figure.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
CAUTION
!
Use new gaskets to prevent oil leakage.
• Place the cylinder head cover on the cylinder head.
• Fit new gaskets to each head cover bolt.
CAUTION
!
Use new gaskets to prevent oil leakage.
• Apply engine oil to both sides of the gaskets.
I823H1140089-04
I823H1140090-01