Suzuki GSX1300R Manual page 316

1D-95 Engine Mechanical:
6) Remove the lower crankcase and measure the width
of compressed plastigauge using the envelope
scale. This measurement should be taken at the
widest part of the compressed plastigauge. If the oil
clearance exceeds the service limit, select the
specified bearings from the bearing selection table.
Crankshaft journal oil clearance
Standard: 0.010 – 0.028 mm (0.0004 – 0.0011 in)
Crankshaft journal oil clearance
Service limit: 0.080 mm (0.0031 in)
Selection
1) Check the corresponding crankcase journal I.D.
codes "A" ([A] or [B]), which are stamped on the rear
of the upper crankcase.
"A"
Crankcase journal I.D. specification
Code "A"
A
B
C
I823H1140291-02
I823H1140292-02
I.D. specification
43.000 – 43.006 mm
(1.6929 – 1.6931 in)
43.006 – 43.012 mm
(1.6931 – 1.6934 in)
43.012 – 43.018 mm
(1.6934 – 1.6936 in)
2) Check the corresponding crankshaft journal O.D.
codes "B" ([A], [B] or [C]), which are stamped on the
crankshaft.
"B"
3) Measure the crankshaft O.D. with the special tool. If
any of the measurements are out of specification,
replace the crankshaft.
Crankshaft journal O.D. specification
Code "B"
A
B
C
Special tool
(A): 09900–20202 (Micrometer (1/100 mm,
25 – 50 mm))
(A)
I823H1140293-01
O.D. specification
39.994 – 40.000 mm
(1.5746 – 1.5748 in)
39.988 – 39.994 mm
(1.5743 – 1.5746 in)
39.982 – 39.988 mm
(1.5741 – 1.5743 in)
I823H1140294-01