To Sensor Removal And Installation; Stp Sensor Inspection; Stp Sensor Adjustment - Suzuki GSX1300R Manual

1C-7 Engine Electrical Devices:

TO Sensor Removal and Installation

Removal
1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
2) Disconnect the coupler and remove the TO sensor
(1).
Installation
Install the TO sensor in the reverse order of removal.
Pay attention to the following point:
• When installing the TO sensor, bring the "UPPER"
letters upward.
B815H21306018
1
I815H1130015-01
I815H1130016-01

STP Sensor Inspection

Refer to "DTC "C29" (P1654-H/L): Secondary Throttle
Position Sensor (STPS) Circuit Malfunction in Section
1A (Page 1A-75)".

STP Sensor Adjustment

Adjust the STP sensor in the following procedures:
1) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)".
2) Disconnect the STVA lead wire coupler (1).
3) Insert the needle pointed probes to the STP sensor
coupler (2) (between Y and B wires).
4) Turn the ignition switch ON.
B815H21306019
B815H21306020
I815H1130017-01