Suzuki GSX1300R Manual page 177

Troubleshooting (When Indicating C44/P0135:)
NOTE
After repairing the trouble, clear the DTC using SDS tool. Refer to "Use of SDS Diagnosis Reset
Procedures (Page 1A-14)".
Step
1 1) Turn the ignition switch OFF.
2) Remove the right side cowling. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-14)".
3) Check the HO2 sensor coupler (1) for loose or poor
contacts.
If OK, then measure the HO2 sensor resistance.
4) Disconnect the HO2 sensor coupler and measure the
resistance between terminals.
CAUTION
!
• Temperature of the sensor affects resistance
value largely.
• Make sure that the sensor heater is in
atmospheric temperature.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
HO2 sensor heater resistance
Approx. 8 Ω at 23 °C (73 °F)
(W – W)
Is the resistance OK?
Action
1
I823H1110092-01
(A)
I815H1110028-02
Engine General Information and Diagnosis:
Yes
Go to Step 2.
1A-106
No
Replace the HO2
sensor with a new one.
Refer to "HO2 Sensor
Removal and
Installation in Section
1C (Page 1C-10)".