Generator Removal and Installation
Removal
1) Disconnect the battery (–) lead wire. Refer to
"Battery Removal and Installation (Page 1J-14)".
2) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
3) Remove the left side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
4) Lift and support the fuel tank.
5) Disconnect the CKP sensor coupler (1) and
generator coupler (2).
6) Remove the generator cover (3).
7) Remove the gasket (4) and dowel pins (5).
5
B815H21A06005
1
2
I815H11A0003-01
3
I815H11A0004-01
4
5
I815H11A0005-01
8) Hold the generator rotor with the special tool.
Special tool
(A): 09930–44530 (Rotor holder)
9) Remove the generator rotor bolt and washer.
(A)
10) Remove the generator rotor (6) with the special tool.
Special tool
(A): 09930–44530 (Rotor holder)
(B): 09930–30450 (Rotor remover bolt)
(B)
(A)
Charging System:
1J-6
I815H11A0006-02
6
I815H11A0007-01