Gearshift Lever Removal And Installation; Gearshift Lever Height Inspection And Adjustment; Gearshift Shaft / Gearshift Cam Plate Components - Suzuki GSX1300R Manual

5B-14 Manual Transmission:

Gearshift Lever Removal and Installation

Removal
Remove the gearshift lever as shown in the gearshift
lever construction. Refer to "Gearshift Lever
Construction (Page 5B-13)".
Installation
1) Install the gearshift lever as shown in the gearshift
lever construction. Refer to "Gearshift Lever
Construction (Page 5B-13)".
2) After installing the gearshift lever, check the gearshift
lever height. Refer to "Gearshift Lever Height
Inspection and Adjustment (Page 5B-14)".
Gearshift Lever Height Inspection and
Adjustment
Inspect and adjust the gearshift lever height in the
following procedures:
1) Inspect the gearshift lever height "a" between the
lever top and footrest.
Adjust the gearshift lever height if necessary.
Gearshift lever height "a"
Standard: 50 – 60 mm (2.0 – 2.4 in)
"a "
2) Loosen the lock-nuts (1).
B815H25206010
3) Turn the gearshift link rod (2) until the gearshift lever
is 50 – 60 mm (2.0 – 2.4 in) below the top of the
footrest.
4) Tighten the lock-nuts securely.
B815H25206011
Gearshift Shaft / Gearshift Cam Plate
Components
(a)
I823H1520029-02
2
1
3
4
2
1
1. Gearshift shaft
2. Gearshift shaft return spring
3. Gearshift cam drive plate
4. Gearshift plate return spring
: 19 N⋅m (1.9 kgf-m, 13.5 lb-ft)
: Apply thread lock to the thread part.
: Do not reuse.
I823H1520030-01
B815H25206012
I823H1520097-01