1G-14 Fuel System:
• When installing the fuel pump assembly, first tighten
all the fuel pump mounting bolts lightly and then to the
specified torque.
Tightening torque
Fuel pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0
lb-ft)
Fuel Mesh Filter Inspection and Cleaning
Inspect the fuel mesh filter in the following procedures:
1) Remove the fuel mesh filter. Refer to "Fuel Pump
Disassembly and Assembly (Page 1G-12)".
2) If the fuel mesh filter is clogged with foreign particles,
it hinders smooth gasoline flow resulting in loss of
engine power. Such a filter should be cleaned by
blowing with compressed air.
NOTE
When the fuel mesh filter is dirtied
excessively, replace the fuel filter cartridge
with a new one.
3) After finishing the fuel mesh filter inspection, reinstall
the fuel mesh filter. Refer to "Fuel Pump
Disassembly and Assembly (Page 1G-12)".
Fuel Injector / Fuel Delivery Pipe / T-joint
Removal and Installation
Refer to "Throttle Body Disassembly and Assembly in
Section 1D (Page 1D-12)".
Fuel Injector Inspection and Cleaning
Inspect the fuel injector in the following procedures:
1) Remove the fuel injector. Refer to "Throttle Body
Disassembly and Assembly in Section 1D (Page 1D-
12)".
2) Check the fuel injector filter for evidence of dirt and
contamination. If present, clean and check for
presence of dirt in the fuel lines and fuel tank.
I815H1170026-01
B815H21706012
3) Install the fuel injector. Refer to "Throttle Body
Disassembly and Assembly in Section 1D (Page 1D-
12)".
I823H1170025-01
B815H21706013
B815H21706014
I823H1170026-01