Front Wheel Related Parts Inspection - Suzuki GSX1300R Manual

8) Install the front fender, side cowlings and rear under
cowlings.

Front Wheel Related Parts Inspection

Refer to "Front Wheel Assembly Removal and
Installation (Page 2D-4)".
Tire
Refer to "Tire Inspection in Section 0B (Page 0B-19)".
Front Brake Disc
Refer to "Front Brake Disc Inspection in Section 4B
(Page 4B-7)".
Dust Seal
Inspect the dust seal lips for wear or damage. If any
defects are found, replace the dust seal with a new ones.
Refer to "Front Wheel Dust Seal / Bearing Removal and
Installation (Page 2D-7)".
Wheel Axle
Using a dial gauge, check the wheel axle for runout. If
the runout exceeds the limit, replace the axle shaft.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
Wheel axle runout
Service limit: 0.25 mm (0.010 in)
(A)
(C)
Wheel
1) Remove the brake pads. Refer to "Front Brake Pad
2) Make sure that the wheel runout checked as shown
B815H22406004
3) Install the brake pads. Refer to "Front Brake Pad
Wheel Bearing
Inspect the play of the wheel bearings by finger while
they are in the wheel. Rotate the inner race by finger to
inspect for abnormal noise and smooth rotation. Replace
the bearing if there is anything unusual. Refer to "Front
I823H1240012-01
Wheel Dust Seal / Bearing Removal and Installation
(Page 2D-7)".
(B)
I649G1240054-02
Replacement in Section 4B (Page 4B-2)".
in the figure does not exceed the service limit. An
excessive runout is usually due to worn or loosened
wheel bearings and can be reduced by replacing the
bearings. If bearing replacement fails to reduce the
runout, replace the wheel.
Replacement in Section 4B (Page 4B-2)".
Wheel rim runout
Service limit (Axial and Radial): 2.0 mm (0.08 in)
Wheels and Tires: 2D-6
I649G1240014-02
I649G1240015-02