Suzuki GSX1300R Manual page 382

1H-8 Ignition System:
4) Connect all the ignition coil/plug cap lead wire
couplers to the ignition coil/plug caps respectively,
and ground them on the cylinder head (each spark
plug hole).
CAUTION
!
Avoid grounding the spark plugs and
suppling the electrical shock to the cylinder
head cover (magnesium parts) to prevent the
magnesium material from damage.
NOTE
Be sure that all the spark plugs are
connected properly and the battery used is in
fully-charged condition.
1
1. New spark plug
"A": Contact the spark plug to the cylinder head.
5) Insert the needle pointed probe to the lead wire
6) Connect the multi-circuit tester with the peak voltage
Ignition coil/Plug cap #1
Ignition coil/Plug cap #2
Ignition coil/Plug cap #3
Ignition coil/Plug cap #4
"A"
I823H1180011-02
coupler.
CAUTION
!
Use the special tool to prevent the rubber of
the water proof coupler from damage.
adaptor as follows.
CAUTION
!
Before using the multi-circuit tester and peak
voltage adaptor, refer to the appropriate
instruction manual.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe
set)
Tester knob indication: Voltage (
(B)
3
"B"
2
2. ECM
3. Peak voltage adaptor
4. New spark plug
5. Ignition coil
)
(+) Probe (–) Probe
W/Bl wire
Ground
terminal
Black wire
Ground
terminal
Yellow wire
Ground
terminal
Green wire
Ground
terminal
(A)
I718H1180003-02
"C"
"D"
5
4
I823H1180026-01
"B": (+) probe
"C": (–) probe
"D": To engine stop switch