Suzuki GSX1300R Manual page 501

3) Squeeze and release the brake lever several times
in rapid succession and squeeze the lever fully
without releasing it.
4) Loosen the air bleeder valve by turning it a quarter of
a turn so that the brake fluid runs into the receptacle,
this will remove the tension of the brake lever
causing it to touch the handlebar grip.
5) Close the air bleeder valve, pump and squeeze the
lever, and open the valve.
6) Repeat this process until the fluid flowing into the
receptacle no longer contains air bubbles.
NOTE
While bleeding the brake system, replenish
the brake fluid in the reservoir as necessary.
Make sure that there is always some fluid
visible in the reservoir.
7) Close the air bleeder valve and disconnect the hose.
Tightening torque
Air bleeder valve (Front): 7.5 N·m (0.75 kgf-m,
5.5 lb-ft)
Brake Control System and Diagnosis:
8) Fill the reservoir with brake fluid to the upper mark of
the reservoir.
9) Install the reservoir cap.
I815H1410011-02
Rear Brake
Bleed air from the rear brake system as the same
manner of front brake.
• Remove the frame cover. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
NOTE
The only difference of bleeding operation
from the front brake is that the rear master
cylinder is actuated by a pedal.
Tightening torque
Air bleeder valve (Rear): 7.5 N·m (0.75 kgf-m, 5.5
lb-ft)
I815H1410012-01
4A-5
I815H1410013-01
I815H1410014-01
I815H1410015-02