Fuel Level Gauge Inspection; Speedometer Inspection; Speed Sensor Removal And Installation - Suzuki GSX1300R Manual

9C-6 Combination Meter / Fuel Meter / Horn:

Fuel Level Gauge Inspection

Inspect the fuel level gauge in the following procedures:
1) Remove the fuel pump. Refer to "Fuel Pump
Disassembly and Assembly in Section 1G (Page 1G-
12)".
2) Measure the resistance at each fuel level gauge in
float position. If the resistance is incorrect, replace
fuel level gauge with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
Float position
Full "a"
Empty "b"
" a "
" b "
"a": 241.2 mm (9.50 in)
3) Install the fuel pump. Refer to "Fuel Pump
Disassembly and Assembly in Section 1G (Page 1G-
12)".

Speedometer Inspection

If the speedometer, odometer or tripmeter does not
function properly, inspect the speed sensor and the
coupler connections. If the speed sensor and coupler
connections are OK, replace the combination meter unit
with a new one. Refer to "Combination Meter Removal
and Installation (Page 9C-2)".
B815H29306008
Resistance
11 – 13 Ω
130 – 135 Ω
I815H1930013-01
"b": 55 mm (2.17 in)
B815H29306009

Speed Sensor Removal and Installation

Removal
1) Remove the left side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
2) Disconnect the speed sensor lead wire coupler (1).
3) Remove the speed sensor (2).
Installation
Install the speed sensor in the reverse order of removal.
Pay attention to the following points:
• Tighten the speed sensor mounting bolt (1) to the
specified torque.
Tightening torque
Speed sensor mounting bolt (a): 6.5 N·m (0.65
kgf-m, 4.7 lb-ft)
• Route the speed sensor lead wire. Refer to "Wiring
Harness Routing Diagram in Section 9A (Page 9A-5)".
B815H29306010
1
I815H1930014-01
2
I815H1930015-01
1
(a)
I815H1930016-01