Crank Balancer Inspection; Conrod Removal And Installation - Suzuki GSX1300R Manual

Suzuki gsx1300r motorcycle

Hide thumbs Also See for GSX1300R:

Table of Contents

1D-89 Engine Mechanical:

• Apply molybdenum oil solution to the bearings,

spacers and washers.

M/O: Molybdenum oil (MOLYBDENUM OIL

Crank Balancer Inspection

Refer to "Crank Balancer Disassembly and Assembly

(Page 1D-88)".

Inspect the damper for wear and damage, replace it if

any defects are found.

Bearing and Washer

Inspect the bearings and the washers for wear or

damage. Replace the bearing or the washer if there is

anything unusual.

Balancer Shaft

Inspect the balancer shaft for wear or damage. Replace

the balancer shaft if there is anything unusual.

I823H1140272-04

B815H21406038

1) Remove the crankshaft assembly from the

crankcase. Refer to "Engine Bottom Side

Disassembly (Page 1D-63)".

2) Loosen the conrod cap bolts using a 10 mm, 12 point

socket wrench, then tap the conrod cap bolts lightly

with plastic hammer to remove the conrod cap.

3) Remove the conrods and mark them to identify their

respective cylinders.

I823H1140273-01

I823H1140274-02

I823H1140275-01

B815H21406039

I823H1140276-02

Table of Contents