Suzuki GSX1300R Manual page 398

1I-9 Starting System:
4) Install the turn signal/side-stand relay. Refer to "Turn
Signal / Side-stand Relay Removal and Installation
(Page 1I-7)".
Diode inspection
1) Remove the turn signal/side-stand relay. Refer to
"Turn Signal / Side-stand Relay Removal and
Installation (Page 1I-7)".
2) Measure the voltage between the "A", "B" and "C"
terminals using the multi-circuit tester.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test ( )
"A"
"B"
"C"
+
"B",
"B", "C"
"A" 0.4
NOTE
If the multi circuit tester reads 1.4 V and
below when the tester probes are not
connected, replace its battery.
3) Install the turn signal/side-stand relay. Refer to "Turn
Signal / Side-stand Relay Removal and Installation
(Page 1I-7)".
"C" "A" "B"
I649G1190029-02
Probe of tester to:
"C" "A"
1.4 V and more
(Tester's battery voltage)
– 0.6 V
I649G1190046-04
Gear Position Switch
1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
2) Disconnect the gear position switch coupler (1).
CAUTION
!
When disconnecting and connecting the gear
position switch coupler, make sure to turn off
the ignition switch, or electronic parts may
get damaged.
1
3) Check the continuity between Bl and B lead wires
with the transmission in "neutral".
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test (
ON (Neutral)
OFF (Except neutral)
4) Connect the gear position switch coupler to the
wiring harness.
5) Insert the needle pointed probes to the lead wire
coupler.
6) Turn the ignition switch ON and side-stand to upright
position.
I823H1110072-01
)
BI B
I823H1190016-01