6B-3 Steering / Handlebar:
Handlebar Removal and Installation
Removal
1) Remove the following parts from the left handlebar.
a) Clutch master cylinder/clutch lever (1)
CAUTION
!
Do not turn the clutch master cylinder upside
down.
b) Left handlebar switch box (2)
c) Handlebar balancer (3)
d) Grip rubber (4)
2
4
3
2) Remove the following parts from the right handlebar.
a) Front brake master cylinder/Front brake lever (5)
CAUTION
!
Do not turn the front brake master cylinder
upside down.
b) Right handlebar switch box (6)
c) Handlebar balancer (7)
d) Throttle grip (8)
B815H26206003
1
I815H1620003-01
5
6
8
7
I815H1620004-01
3) Remove the handlebar clamp bolts (9).
4) Detach the right and left handlebars (10).
10
Installation
Install the handlebars in the reverse order of removal.
Pay attention to the following points:
• Install the handlebars and align the cutaway of the
handlebar with the handlebar clamp bolts hole "A".
"A"
• Tighten the handlebar clamp bolts (1).
Tightening torque
Handlebar clamp bolt (a): 10 N·m (1.0 kgf-m, 7.0
lb-ft)
1
9
I815H1620005-01
I815H1620006-01
I815H1620007-01