Suzuki GSX1300R Manual page 162

1A-91 Engine General Information and Diagnosis:
Step
2 1) Turn the ignition switch ON.
2) Measure the injector voltage between the Y/R wire and
ground.
NOTE
Injector voltage can be detected only for 3
seconds after ignition switch is turned ON.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage ( )
Injector voltage
Battery voltage
((+) terminal: Y/R – (–) terminal: Ground)
Is the voltage OK?
Action
(A)
V
I823H1110083-02
Yes
• Lg wire open or
shorted to the
ground, or poor "64"
connection (#1
cylinder side).
• Lg/W wire open or
shorted to the
ground, or poor "63"
connection (#2
cylinder side).
• Lg/G wire open or
shorted to the
ground, or poor "62"
connection (#3
cylinder side).
• Lg/Bl wire open or
shorted to the
ground, or poor "61"
connection (#4
cylinder side).
• If wire and
connection are OK,
intermittent trouble or
faulty ECM.
• Recheck each
terminal and wire
harness for open
circuit and poor
connection.
• Replace the ECM
with a known good
one, and inspect it
again. Refer to "ECM
Removal and
Installation in Section
1C (Page 1C-2)".
No
Open circuit in the Y/R
wire.