Suzuki GSX1300R Manual page 254

1D-33 Engine Mechanical:
• Insert the No. 2 and No. 3 pistons into the cylinder.
NOTE
Some light resistance must be overcome to
lower the cylinder.
• After inserting the No. 2 and No. 3 pistons in place,
insert the No. 1 and No. 4 pistons in the same manner
of the No. 2 and No. 3 pistons.
NOTE
When installing the cylinder block, keep the
cam chain taut. The cam chain must not be
caught between cam drive sprocket and
crankcase when turning the crankshaft.
• Tighten the cylinder nuts (M6) temporarily.
• Install the water hose (2).
2
Cylinder Head
• Pull the cam chain out of the cylinder and install the
cam chain guide No. 1 (1).
CAUTION
!
• There is the guide holder "A" for the
bottom end of the cam chain guide No. 1
(1) cast in the crankcase.
• Be sure that the cam chain guide No. 1 (1)
is installed properly.
I823H1140058-01
• Fit the dowel pins and a new cylinder head gasket (2)
to the cylinder.
I823H1140059-01
CAUTION
!
Use a new gasket to prevent gas leakage.
1 "A"
2
1
I823H1140060-01
I823H1140061-01
I823H1140062-01