Clutch Parts Inspection - Suzuki GSX1300R Manual

• Tighten the clutch outer cover bolts (20) with the
washers (21) securely.
20
• Install the clutch cover and tighten its bolts (22) to the
specified torque.
Tightening torque
Clutch cover bolt (c): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE
Fit the clamp to the bolt (22).
• Rout the HO2 sensor and oil pressure switch lead
wires properly. Refer to "Wiring Harness Routing
Diagram in Section 9A (Page 9A-5)".
21
I823H1530055-01
22
(c)
I815H1530061-02

Clutch Parts Inspection

Refer to "Clutch Removal (Page 5C-14)" and "Clutch
Installation (Page 5C-17)".
Clutch Drive and Driven Plate
NOTE
Wipe off the engine oil from the drive and
driven plates with a clean rag.
Measure the thickness of drive plates with a vernier
calipers. If the drive plate thickness is found to have
reached the limit, replace it with a new one.
Special tool
(A): 09900–20102 (Vernier calipers (1/20 mm,
200 mm))
Clutch drive plate thickness
Service limit (No. 1 drive plate): 2.62 mm (0.103 in)
Service limit (No. 2 and No. 3 drive plates): 3.42 mm
(0.135 in)
Measure the claw width of drive plates with a vernier
calipers. Replace the drive plates found to have worn
down to the limit.
Special tool
(A): 09900–20102 (Vernier calipers (1/20 mm,
200 mm))
Clutch: 5C-21
B815H25306018
(A)
I649G1530056-03