Crankshaft Thrust Clearance Inspection And Selection - Suzuki GSX1300R Manual

4) Select the specified bearings from the bearing
selection table.
Bearing selection table
Code
A Green
Crankcase
B Black
I.D. "A"
Brown
C
Bearing thickness specification
Color "C" (Part No.)
Green
(12229-15H00-0A0)
Black
(12229-15H00-0B0)
Brown
(12229-15H00-0C0)
Yellow
(12229-15H00-0D0)
Blue
(12229-15H00-0E0)
"C": Color code
Crankshaft O.D. "B"
A B C
Black Brown
Brown Yellow
Yellow Blue
I823H1140299-01
Thickness
1.492 – 1.495 mm
(0.0587 – 0.0589 in)
1.495 – 1.498 mm
(0.0589 – 0.0590 in)
1.498 – 1.501 mm
(0.0590 – 0.0591 in)
1.501 – 1.504 mm
(0.0591 – 0.0592 in)
1.504 – 1.507 mm
(0.0592 – 0.0593 in)
"C"
I718H1140303-01
Crankshaft Thrust Clearance Inspection and
Selection
Refer to "Engine Bottom Side Disassembly (Page 1D-
63)".
Refer to "Engine Bottom Side Assembly (Page 1D-71)".
Inspection
1) With the crankshaft's right-side and left-side thrust
bearings inserted into the upper crankcase.
2) Measure the thrust clearance "a" between the left-
side thrust bearing and crankshaft using the
thickness gauge. If the thrust clearance exceeds the
standard range, adjust the thrust clearance.
NOTE
Pull the crankshaft to the left (generator side)
so that there is no clearance on the right-side
thrust bearing.
Special tool
(A): 09900–20803 (Thickness gauge)
Crankshaft thrust clearance "a"
Standard: 0.055 – 0.110 mm (0.0022 – 0.0043 in)
2
1. Right-side thrust bearing
2. Left-side thrust bearing
(A)
Engine Mechanical: 1D-96
B815H21406043
1
"A"
I823H1140295-02
"A": Front side
" a "
I823H1140297-02