Oil Pressure Switch Removal And Installation - Suzuki GSX1300R Manual

1E-9 Engine Lubrication System:
4) Remove the oil cooler guard (3).
5) Remove the oil cooler (4).
4
Installation
Install the oil cooler and oil cooler hoses in the reverse
order of removal. Pay attention to the following points:
• Apply engine oil to the O-rings.
CAUTION
!
Replace the O-rings with new ones to prevent
oil leakage.
• Tighten the oil cooler hose bolts to the specified
torque.
Tightening torque
Oil cooler hose bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Pour engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
• Install the removed parts.
3
I815H1150014-01
I823H1150030-01
I815H1150015-01

Oil Pressure Switch Removal and Installation

Refer to "Electrical Components Location in Section 0A
(Page 0A-8)".
Removal
1) Turn the ignition switch OFF.
2) Remove the right side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
3) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
4) Disconnect the oil pressure switch lead wire (1).
5) Remove the oil pressure switch (2).
1
Installation
1) Install the oil pressure switch (1), apply a bond lightly
to its thread and tighten it to the specified torque.
: Sealant 99000–31140 (SUZUKI Bond
1207B or equivalent)
Tightening torque
Oil pressure switch (a): 14 N·m (1.4 kgf-m, 10.0
lb-ft)
B815H21506007
2
I815H1150016-01
1
(a)
I815H1150017-01