Sbc Parameters - AudioCodes Mediant 800B User Manual

61.11 SBC Parameters

The SBC and CRP parameters are described in the table below.
Parameter
CRP-specific Parameters
CRP Application
enable-crp
[EnableCRPApplication]
CRP Survivability Mode
crp-survivability-mode
[CRPSurvivabilityMode]
crp-gw-fallback
[CRPGatewayFallback]
SBC-specific Parameters
Enable SBC
enable-sbc
[EnableSBCApplication]
SBC and CRP Parameters
Unclassified Calls
unclassified-calls
[AllowUnclassifiedCalls]
User's Manual
Table 61-72: SBC and CRP Parameters
Enables the CRP application.

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is
required.
Defines the CRP mode.

[0] Standard Mode (default)

[1] Always Emergency Mode

[2] Auto-answer REGISTER
Enables fallback routing from the proxy server to the
Gateway (PSTN).

[0] = Disable (default)

[1] = Enable
Enables the Session Border Control (SBC) application.

[0] Disable (default)

[1] Enable
Notes:

For the parameter to take effect, a device reset is
required.

In addition to enabling the parameter, the number of
maximum SBC/IP-to-IP sessions must be included in
the Software License Key.
Determines whether incoming calls that cannot be
classified (i.e. classification process fails) to a Source IP
Group are rejected or processed.

[0] Reject = (Default) Call is rejected if classification
fails.

[1] Allow = If classification fails, the incoming packet is
assigned to a source IP Group (and subsequently
processed) as follows:

The source SRD is determined according to the SIP
Interface to where the SIP-initiating dialog request
is sent. The source IP Group is set to the default IP
Group associated with this SRD.

If the source SRD is ID 0, then source IP Group ID
0 is chosen. In case of any other SRD, then the first
IP Group associated with this SRD is chosen as the
source IP Group or the call. If no IP Group is
associated with this SRD, the call is rejected.
1140
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296