Workflow For Initial Setup Of The Device - Fujitsu XG0224 User Manual

XG Series User's Guide
3.1

Workflow for Initial Setup of the Device

This section describes the procedures to setup the device.
1) Prepare a terminal
Prepare a terminal for the initial configuration.
2) "Besic Setting Up"
Connect the device and terminal with an RS232C cable. The band rate setting is 9,600 bps.
To configure the Device basically, carry out the following procedure.
Login:admin
Password:
XG2600# configure
XG2600(config)# sysname HOST-NAME
XG2600(config)# time zone -0500
XG2600(config)# date YYYY/MM/DD.hh:mm:ss
XG2600(config)# password admin set
Password:
Retype password:
XG2600(config)# save
XG2600(config)# reset
3) Turn on the device to start the system.
Turn on the terminal and the device to start the system.
4) "Configure LAN Interface"
The initial setting of the LAN interface is for only IPv6 link-local address.
To use the following functions, set up the LAN interface:
- Telnet connection
- SNMP manager connection
- System log transmission
- Time synchronization using an NTP/SNTP server
- Configuration file upload/download
- Firmware update
- Collection of maintenance information
5) "Telnet Connection via the LAN Interface (Optional)"
The initial setting of the Telnet connection via the management LAN interface is disabled.
Enable telnet connection if necessary.
6) "SNMP Configuration (Optional)"
Initially, the SNMP agent configuration is not set.
Set the SNMP configuration as needed.
7) This is the end of the preparation procedure
Proceed with configuring the switch.
Command
Login to the device from the serial terminal. The user name is
"admin". The default password is not set.
Switch to Configuration mode.
Set the device name (HOST-NAME).
Set time zone.
Set date and time.
Set the password for user "admin".
Type password.
Retype password.
Save the configuration.
Reset the device.
56
Chapter 3 Installation
Task

Workflow for Initial Setup of the Device