Ether L3 Monitor Information; Ether Icmpwatch Address - Fujitsu XG0224 User Manual

Hide thumbs Also See for XG0224:
Table of Contents

Advertisement

XG Series User's Guide
5.1.8

ether L3 Monitor Information

This section explains about the commands related to ether L3 monitor information.
5.1.8.1

ether icmpwatch address

Function
Available Model
Syntax
Options
Use Mode
Explanation
Caution
Default
Set the destination address for Ethernet L3 monitoring.
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
ether <number> icmpwatch address <dst_addr>
<number>
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<dst_addr>
• Destination IP address of ICMP ECHO packets
Specify the destination IP address to be monitored.
The allowable range is as follows:
1.0.0.1to 126.255.255.254
128.0.0.1 to 191.255.255.254
192.0.0.1 to 223.255.255.254
Configuration mode (admin class)
Set the operation information for destination monitoring.
The ICMP ECHO packet is sent from the specified Ethernet port to the destination IP
address specified by <dst_addr>, and its presence is checked by receiving a response.
Do not set the IP address of the local device in <dst_addr>. Also, make sure that the
specified IP address is included in the same subnet.
If any of the above three addresses are specified, the Ethernet L3 monitoring function will
not operate normally.
If the ether type is linkaggregation
The Ethernet L3 monitoring definition that has been set for the Ethernet port is disabled.
Set the Ethernet L3 monitoring definition for the "linkaggregation icmpwatch".
When using both the backup port function and the Ethernet L3 monitoring
function
The active port is monitored.
When a port is first linked up, it is used as the operation port in the earlier mode.
Therefore, set the port monitoring for both the master and backup ports.
It is assumed that the Ethernet L3 monitoring function is not used.
149
Chapter 5 Command Reference
Port Information Settings

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xg0448Xg2600Xg0440dcXg0440dcr

Table of Contents