Serverinfo Telnet Ip6; Serverinfo Telnet Filter - Fujitsu XG0224 User Manual

XG Series User's Guide

5.15.8.16 serverinfo telnet ip6

Function
Available Model
Syntax
Options
Use Mode
Explanation
Default

5.15.8.17 serverinfo telnet filter

Function
Available Model
Syntax
Options
Use Mode
Set the IPv6 telnet server function
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
serverinfo telnet ip6 <mode>
<mode>
• on
Enable telnet server function
• off
Disable telnet server function
Configuration mode (admin class)
Set the IPv6 telnet server function
It is assumed that the IPv6 TELNET server function is enabled.
serverinfo telnet ip6 on
Set the application filter for the TELNET server function.
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
serverinfo telnet filter <count> <action> acl <acl_count>
<count>
• Filtering definition number
Specify a definition number, which indicates a filtering priority, with a decimal value
from 0 to 29.
A smaller value has a higher priority.
<action>
Specify an operation when filtering conditions are satisfied.
• accept
Transmit the relevant packet.
• reject
Block the relevant packet.
<acl_count>
• ACL definition number
Specify the required ACL definition number with a decimal value.
If the ACL specified in <acl_count> is not specified, the filtering definition will be
disabled and ignored.
The following ACL definition is available for application filtering.
- ip
Set only the source IP address and the number of mask bits.
If the ip value is not set, the filtering definition will be disabled and ignored.
- ip6
Source IPv6 address and the prefix length are used for the filter.
If IPv6 value has not been set, the filtering definition will be disabled and ignored.
Configuration mode (admin class)
314
Chapter 5 Command Reference
Device Information Settings