Fujitsu XG0224 User Manual page 136

XG Series User's Guide
• Upper limit based on "actions"
16 actions for the entire device.
Up to16 actions can be set for the entire device, including the
qos aclmap", "lan ip dscp",
The following commands spend 1 action regardless of multiple use.
1) "vlan protocol" commands
2) "ether qos aclmap"
A smaller Ethernet port number has a higher priority among Ethernet ports.
3) "vlan qos aclmap" command
A smaller VLAN ID has a higher priority among VLANs.
4) "lan ip dscp" command
A smaller lan definition number has a higher priority among lans.
The following commands spend 1 action regardless of multiple use.
- vlan <vid> protocol ipv4
- vlan <vid> protocol ipv6
The following commands spend 1 action for each.
If same <tos_value> is used, the commands use 1 action for them.
If same <dscp_value> is used, the commands use 1 action for them.
If same <queue_value> is used, the commands use 1 action for them.
- ether <number> qos aclmap <count> tos <tos_value> <acl>
- ether <number >qos aclmap <count> dscp <dscp_value> <acl>
- ether <number> qos aclmap <count> queue <queue_value> <acl>
- vlan <vid> qos aclmap <count> tos <tos_value> <acl>
- vlan <vid> qos aclmap <count> dscp <dscp_value> <acl>
- vlan <vid> qos aclmap <count> queue <queue_value> <acl>
- lan <number> ip dscp <count> acl <acl_count> <dscp_value>
The following commands spend 1 action for each.
If same <vid> is used, the commands use 1 action for them.
- vlan <vid> protocol <count> ether
- vlan <vid> protocol <count> llc
Note 5.
When the port type of the Ethernet port is a link aggregation, the same setting is needed
in all the member ports where the link aggregation is composed.
"vlan protocol" commands.
command
136
Chapter 5 Command Reference
"ether qos aclmap", "vlan
Port Information Settings