XG Series User's Guide
5.1.1.13 ether loopdetect frame
Function
Available Model
Syntax
Options
Use Mode
Explanation
Default
Enable the Loop Detection Frame sender.
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
ether <number> loopdetect frame <target>
<number>
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<target>
Set the sender of loopdetect-frame.
• own
A Loop is detected when receiving a Loop Detection frame from this device.
• any
A Loop is detected when receiving a Loop Detection frame from any device.
Configuration mode (admin class)
Specify the sender of Loop Detection frames used to detect a loop.
The following is the port which is blocked/offlined when a loop is detected.
<target>
Sender of Loop Detection frame
own
This device
any
This device
Other device
It is assumed that set the sender as own.
ether <number> loopdetect frame own
The port reporting the Loop Detection
frame
The port reportinging the Loop Detection
frame
The port receiving the Loop Detection
frame
104
Chapter 5 Command Reference
The port which is blocked/offlined
Port Information Settings