Fujitsu XG0224 User Manual page 41

XG Series User's Guide
Privilege classes (admin class and user class)
Two privilege classes are available; admin class (login as admin) and user class (login as user).
• admin class
All commands can be run.
However, admin commands and su commands cannot be run because it is not necessary to run them in admin class.
• user class
Only a portion of operation commands can be run. Configuration commands cannot be run. You can run an admin
command to transfer to admin class.
If a password aaa command has been used to specify use of the AAA user information (aaa user id command) or RADIUS
server user information as the login user information, the user name privilege class is determined as follows:
• When using RADIUS server
Determined according to the Filter-ID attribute information configured in the RADIUS server.
RADIUS attribute (number)
Filter-ID (11)
• When using user information on the device
Determined according to aaa user user-role command settings.
Use modes (operation mode and configuration mode)
Two use modes are available; operation mode and configuration mode.
• Operation mode
Only operation commands can be run.
• Configuration mode
Both configuration commands and operation commands can be run.
The use mode immediately after logging into the system is operation mode.
The table below displays user names and corresponding passwords, as well as privilege class and use mode after login.
Login user Default password
name
admin None
(blank) (Hit ENTER)
user Not set
(login not possible [*])
*) To log into the system as user, configure password information for the user.
For admin class
For user class
Password configuration
information
password admin set
password user set
Setting
: "administrator"
: "user"
Login privilege
command
admin class
user class
41
Chapter 2 Using the CLI
Login use mode
class
Operation mode
Operation mode
Overview of the CLI